Aquata seal 200 Hybrid | Marmoline | Στεγανωτικά Ταρατσών
1504-2 ce eng



Ready-to-use hybrid brushable solvent-free, acrylic-based, white elastomeric sealant, modified with polyurethane resins.


Plastic containers of 5 kg and 13 kg




Application Temperature

+5°C to +35°C

Application Tools

Roller, grass brush or paint brush


1.0 – 1.5 kg/m² depending on the substrate

Internal Use

Download the relevant technical files:


Use it for an excellent waterproofing of roofs/terraces, balconies, parapets, gutters, plasterboards etc. It can be also applied on older coatings of the same or similar materials, to renew the surfaces, provided that the old surface has been very well prepared (see application mode).


  • Ready to use white material
  • Strong adhesion to various surfaces
  • The application surface does not need to be smooth
  • Creates a single sealed and elastic membrane without joints
  • Allows the substrate to breathe due to its water vapour permeability
  • Highly resistant to extreme temperatures of heat and cold
  • Resistant to the sun, and reflective of solar radiation
  • Before use, clean the substrate from dust, loose material, etc. For application on older coatings of the same or similar materials, the old surface must first be thoroughly cleaned, any cracks should be repaired and any swollen or loose parts should be removed.
  • New surfaces should be primed with MST 22 roof coating primer (approx. 200 gr/m²). Surfaces with older similar coatings definitely need priming only if they had problematic areas which had been repaired/smoothed.
  • Mix well before use.
  • If there are cracks of more than 1 mm, they should be repaired with one of MARMOLINE’s repair materials.
  • In case of cracks, it is recommended also to strengthen the material locally with a fibreglass mesh strip 10 cm wide. Apply AQUATA SEAL 200 HYBRID along the crack and then, while it is fresh, fix the fibreglass mesh strip. If there are many cracks all over the surface, reinforce the whole surface with fibreglass mesh. Then apply a layer of the material over the whole length of the reinforcement.
  • Apply with a paint roller or paintbrush. Lay the first layer of the material and, once dry, lay the second layer vertically to the first one.
  • The appropriate temperature for the application is between +5°C to +35°C.
  • The finished surface should not be exposed to the rain, until it dries completely.